i see you have listed span 1channels in span2 & vice-versa change it appropriately On Apr 9, 2013 4:41 PM, "Vishal Kakkar" <vishal.kakkar@gmail.com> wrote:

[span wanpipe wp1] trunk_type => e1 group=dialGrp1 b-channel => 2:1-15 b-channel => 2:17-31 d-channel => 2:16

[span wanpipe wp2] trunk_type => e1 group=dialGrp1 b-channel => 1:1-15 b-channel => 1:17-31 d-channel => 1:16

freetdm/dialGrp1/*a*/xxxxx initiates call from channel 1 of span 2 i.e. (2:1)

freetdm/dialGrp1/*A/*xxxxx initiates call from channel 31 of span 2 i.e. (2:31).. but i was expecting it to be 31st channel of Span1.

Also 2nd question in above config all calls are going through wp1(span2) only.. even if i initiate more than 30 calls simultaneously.. no call goes to wp2(span 1)

Can anyone please help how can i make ascending/descending channel utilization using one single group across both above spans..

Thanks a lot.. FS Rocks.

_________________________________________________________________________ Professional FreeSWITCH Consulting Services: consulting@freeswitch.org http://www.freeswitchsolutions.com

FreeSWITCH-powered IP PBX: The CudaTel Communication Server http://www.cudatel.com

Official FreeSWITCH Sites http://www.freeswitch.org http://wiki.freeswitch.org http://www.cluecon.com

FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org