Freeswitch & DAHDI Kernel drivers / Hardware questions
Hello, i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now. Is this current information? Can't I use dahdi kernel drivers for freeswitch? As the last update to the zaptel drivers is now nearly a year old (1.4.12) and development has, AFAIK, ceased and new stuff only gehts to dahdi, correct me please if I am wrong. Second question, is it possible to use this hardware: 00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02) Subsystem: Cologne Chip Designs GmbH ISDN Board Flags: bus master, medium devsel, latency 16, IRQ 10 I/O ports at e000 [disabled] [size=8] Memory at ee001000 (32-bit, non-prefetchable) [size=256] Capabilities: [40] Power Management version 1 Kernel modules: hisax with openZap? I read in the wiki (openZap.conf_Examples) something about HFC 4 BRI, but i do not know if this is the same as the above mentioned card. I have access to some pcmcia fxo, and pcmcia isdn cards, could they be used? I have as well an soekris board with two pcmcia slots, could i use this with an fxo pcmcia card to actually drive a small home - pbx with freeswitch? I did not find answers for this questions in the wiki :-) best regards -- Raimund Sacherer - RunSolutions Open Source It Consulting - Email: rs@runsolutions.com tel: 625 40 32 08 Parc Bit - Centro Empresarial Son Espanyol Edificio Estel - Local 3D 07121 - Palma de Mallorca Baleares
On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com>wrote:
Hello, i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there.
Is this current information? Can't I use dahdi kernel drivers for freeswitch? As the last update to the zaptel drivers is now nearly a year old (1.4.12) and development has, AFAIK, ceased and new stuff only gehts to dahdi, correct me please if I am wrong.
both dahdi and zaptel work for FreeSWITCH and no headers are needed, we have our own.
00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02) Subsystem: Cologne Chip Designs GmbH ISDN Board Flags: bus master, medium devsel, latency 16, IRQ 10 I/O ports at e000 [disabled] [size=8] Memory at ee001000 (32-bit, non-prefetchable) [size=256] Capabilities: [40] Power Management version 1 Kernel modules: hisax
with openZap? I read in the wiki (openZap.conf_Examples) something about HFC 4 BRI, but i do not know if this is the same as the above mentioned card.
I have access to some pcmcia fxo, and pcmcia isdn cards, could they be used? I have as well an soekris board with two pcmcia slots, could i use this with an fxo pcmcia card to actually drive a small home - pbx with freeswitch?
I don't have experience with such hardware, cannot tell, may be someone else around here may know. -- Moises Silva Software Developer Sangoma Technologies Inc. | 50 McIntosh Drive, Suite 120, Markham ON L3R 9T3 Canada t. 1 905 474 1990 x 128 | e. moy@sangoma.com
On Aug 25, 2009, at 4:24 PM, Moises Silva wrote:
On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com> wrote: Hello,
i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there. Thank you, i did not see any link to OpenZAP_OpenR2, but this page explains a lot for me!
On Tue, Aug 25, 2009 at 7:35 AM, Raimund Sacherer <rs@runsolutions.com>wrote:
On Aug 25, 2009, at 4:24 PM, Moises Silva wrote:
On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com>wrote:
Hello, i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.
You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there.
Thank you, i did not see any link to OpenZAP_OpenR2, but this page explains a lot for me!
FYI, I added a link to the R2 page on the main OpenZAP page. -MC
participants (3)
-
Michael Collins
-
Moises Silva
-
Raimund Sacherer