Hello, i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now. Is this current information? Can't I use dahdi kernel drivers for freeswitch? As the last update to the zaptel drivers is now nearly a year old (1.4.12) and development has, AFAIK, ceased and new stuff only gehts to dahdi, correct me please if I am wrong. Second question, is it possible to use this hardware: 00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02) Subsystem: Cologne Chip Designs GmbH ISDN Board Flags: bus master, medium devsel, latency 16, IRQ 10 I/O ports at e000 [disabled] [size=8] Memory at ee001000 (32-bit, non-prefetchable) [size=256] Capabilities: [40] Power Management version 1 Kernel modules: hisax with openZap? I read in the wiki (openZap.conf_Examples) something about HFC 4 BRI, but i do not know if this is the same as the above mentioned card. I have access to some pcmcia fxo, and pcmcia isdn cards, could they be used? I have as well an soekris board with two pcmcia slots, could i use this with an fxo pcmcia card to actually drive a small home - pbx with freeswitch? I did not find answers for this questions in the wiki :-) best regards -- Raimund Sacherer - RunSolutions Open Source It Consulting - Email: rs@runsolutions.com tel: 625 40 32 08 Parc Bit - Centro Empresarial Son Espanyol Edificio Estel - Local 3D 07121 - Palma de Mallorca Baleares