On Tue, Aug 25, 2009 at 9:35 AM, Raimund Sacherer <rs@runsolutions.com> wrote:

Hello,

i was reading through the openzap wiki page and searched the wiki, the only thing I found about dahdi is a note from January that freeswitch does not work with dahdi right now.

You did not search well enough. http://wiki.freeswitch.org/wiki/OpenZAP_OpenR2 , read note 5 there.

Is this current information? Can't I use dahdi kernel drivers for freeswitch? As the last update to the zaptel drivers is now nearly a year old (1.4.12) and development has, AFAIK, ceased and new stuff only gehts to dahdi, correct me please if I am wrong.

both dahdi and zaptel work for FreeSWITCH and no headers are needed, we have our own.

00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network controller [HFC-PCI] (rev 02)
Subsystem: Cologne Chip Designs GmbH ISDN Board

Flags: bus master, medium devsel, latency 16, IRQ 10
I/O ports at e000 [disabled] [size=8]
Memory at ee001000 (32-bit, non-prefetchable) [size=256]

Capabilities: [40] Power Management version 1
Kernel modules: hisax

with openZap? I read in the wiki (openZap.conf_Examples) something about HFC 4 BRI, but i do not know if this is the same as the above mentioned card.

I have access to some pcmcia fxo, and pcmcia isdn cards, could they be used? I have as well an soekris board with two pcmcia slots, could i use this with an fxo pcmcia card to actually drive a small home - pbx with freeswitch?

I don't have experience with such hardware, cannot tell, may be someone else around here may know.