On Tue, Dec 6, 2011 at 10:20 PM, Moises Silva <moises.silva@gmail.com>wrote:
On Mon, Dec 5, 2011 at 10:52 PM, Ryan V <ryan@kaevee.com> wrote:
Freeswitch recognized the card and here is the output of ftdm list
+OK span: 1 (wp1) type: Sangoma (ISDN) physical_status: ok signaling_status: UP chan_count: 31 dialplan: XML context: public dial_regex: fail_dial_regex: hold_music: analog_options: none
I am stuck here. I don't receive any incoming calls and get a busy message when we dial our main DID no.
Please tell me where I am going wrong?
That looks pretty good to me. Try enabling all debugging output. You can also try to trace the d-channel and dump it to a pcap file to see if you receive any messages from the telco indicating a new call.
http://wiki.sangoma.com/wanpipe-wireshark-pcap-pri-bri-wan-t1-e1-tracing
What about outgoing calls?
I made a stupid mistake of connecting to our existing EPABX instead of connecting to modem :( I figured it out couple of hours back.. and connected it to our Telco modem. I am now receiving the calls. As I am totally newbie to FreeSwitch or soft PBX, I have to figure out how to setup outgoing calls :) In fact, I was about to write to list and update my email soon. Thanks, Venkatesh K