Hi, My first post to the list. I'm a bit of a newb to FreeSwitch (and linux) so apologies if some of my terminology isn't quite correct. Recently had a 9 channel ISDN30 (euro - q931) installed by BT (UK). We've hooked it up to our FreeSwitch setup with a Sangoma A101 card. Light on the card is green and wanrouter is installed and up in TDM_API mode, with the connection status showing as connected. Configured Openzap for 9 b and 1 d channel as described in Freeswitch Wiki. Then created a diaplan to fire off any calls preceded by 9 to the next available openzap channel. The problem I have is when I initiate an external call (using 9xxxxxxx) from an extension I can see Freeswitch allocating the call to the next available channel but then the just sits there and times out after 1 minute. With the cause stated as ORIGINATOR_CANCEL (guessing this is the time out) Here are the confs / dialplan as I have them: [span wanpipe] name => OpenZAP number => 1 trunk_type => e1 b-channel => 1:1-9 d-channel => 1:16 <configuration name="openzap.conf" description="OpenZAP Configuration"> <settings> <param name="debug" value="0"/> <!--<param name="hold-music" value="$${moh_uri}"/>--> <!--<param name="enable-analog-option" value="call-swap"/>--> <!--<param name="enable-analog-option" value="3-way"/>--> </settings> <pri_spans> <span id="1"> <param name="mode" value="user"/> <param name="dialect" value="q931"/> <param name="dialplan" value="XML"/> <param name="context" value="default"/> </span> </pri_spans> </configuration> <include> <extension name="outgoing-pri"> <condition field="destination_number" expression="^9(\d{7,15})$"> <action application="bridge" data="openzap/1/a/$1"/> </condition> </extension> </include> Do the config files look ok? Is there anything else I should be configuring? Is there anything else I can use to debug or get information on the PRI status? Thanks in advance. Mark. Save paper - don't print this email unless you need to. -------------------------------------------------------------------------------- NOTICE from RNID Typetalk This communication contains information which is confidential and may also be privileged. It is for the exclusive use of the addressee. If you are not the addressee, please note that any distribution, dissemination, copying or use of this communication or the information in it is prohibited. If you have received this message in error, please notify the sender immediately at the above e-mail address and delete the information from your computer system. Please note that neither RNID nor the sender accepts any responsibility for viruses and it is your responsibility to scan the email and attachments (if any). --------------------------------------------------------------------------------