Hi,

 

My first post to the list. I’m a bit of a newb to FreeSwitch (and linux) so apologies if some of my terminology isn’t quite correct.

 

Recently had a 9 channel ISDN30 (euro – q931) installed by BT (UK). We’ve hooked it up to our FreeSwitch setup with a Sangoma A101 card. Light on the card is green and wanrouter is installed and up in TDM_API mode, with the connection status showing as connected.  Configured Openzap for 9 b and 1 d channel as described in Freeswitch Wiki. Then created a diaplan to fire off any calls preceded by 9 to the next available openzap channel.

 

The problem I have is when I initiate an external call (using 9xxxxxxx) from an extension I can see Freeswitch allocating the call to the next available channel but then the just sits there and times out after 1 minute. With the cause stated as ORIGINATOR_CANCEL (guessing this is the time out)

 

Here are the confs / dialplan as I have them:

 

[span wanpipe]

name => OpenZAP

number => 1

trunk_type => e1

b-channel => 1:1-9

d-channel => 1:16

 

<configuration name="openzap.conf" description="OpenZAP Configuration">

  <settings>

    <param name="debug" value="0"/>

    <!--<param name="hold-music" value="$${moh_uri}"/>-->

    <!--<param name="enable-analog-option" value="call-swap"/>-->

    <!--<param name="enable-analog-option" value="3-way"/>-->

  </settings>

   <pri_spans>

     <span id="1">

       <param name="mode" value="user"/>

       <param name="dialect" value="q931"/>

       <param name="dialplan" value="XML"/>

       <param name="context" value="default"/>

     </span>

   </pri_spans>

</configuration>

 

<include>

<extension name="outgoing-pri">

<condition field="destination_number" expression="^9(\d{7,15})$">

<action application="bridge" data="openzap/1/a/$1"/>

</condition>

</extension>

</include>

 

Do the config files look ok? Is there anything else I should be configuring? Is there anything else I can use to debug or get information on the PRI status?

 

Thanks in advance.

Mark.