I'm trying to figure out how phrases works in freeswitch, and I have a set of my own voices to use instead of the default ones. I've read http://wiki.freeswitch.org/wiki/Speech_Phrase_Management but I guess I'm not understanding correctly. Situation (might be easier to understand this way): Basically I have a set of prompts (they are actually in my voice) that I plan on using to read off addresses and such from a SIP message. Think "automated dispatching" for fire departments. A script might be: (fire tones) "Indianapolis Engine 123, Indianapolis Medic 123, 928 West Banta Road, Vehicle Fire" x2 "Coordinates 3700 North, 1200 East, Assigned to Marion Ops 1" ...so that information would be set in some variables, like responding_units, address, incident_type, coordinates_1, coordinates_1_direction, coordinates_2, coordinates_2_direction, etc... So the million dollar question is, how do I (temporarily) get freeswitch to use my voice prompts instead of the default prompts when using the say command in the dialplan? Also, how should I organize those prompts so that freeswitch can find them? -- Brian D. Foster Endigo Computer LLC Email: bdfoster@endigotech.com Phone: 317-429-1069 Indianapolis, Indiana, USA This message contains confidential information and is intended for those listed in the "To:", "CC:", and/or "BCC:" fields of the message header.If you are not the intended recipient you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this information is strictly prohibited. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.