Dear All, I have installed Sangoma PRI card in machine with following steps, * wget ftp://ftp.sangoma.com/linux/custom/3.5/wanpipe-3.5.8.7.tgz * tar -xvfz wanpipe-3.5.8.7.tgz * cd wanpipe-3.5.8.7 * make openzap * make install * make install_pri I have executed "wanrouter hwprobe" command it prints the following details, 1 . AFT-A102-SH : SLOT=4 : BUS=3 : IRQ=11 : CPU=A : PORT=1 : HWEC=0 : V=36 2 . AFT-A102-SH : SLOT=4 : BUS=3 : IRQ=11 : CPU=A : PORT=2 : HWEC=0 : V=36 Card Cnt: A101-2=1 Next I have executed wancfg_fs script to configure the sangoma for freeswitch. It creates the following configuration files * wanpipe1.conf * wanpipe2.conf * smg_prid.conf * openzap.conf * openzap.conf.xml I have attached those files. I have started the wanrouter and printed the wanrouter status, Wanrouter Status: Device name | Protocol | Station | Status | wanpipe1 | AFT TE1 | N/A | Connected | wanpipe2 | AFT TE1 | N/A | Disconnected | Next I have started the smg_ctrl, but it failed to start. It prints the following things, smg_ctrl start Starting processes... Loading SCTP...OK Starting sangoma_prid...OK sangoma_prid failed to start check /var/log/sangoma_mgd.log for errors Stopping running processes... safe_sangoma not running... sangoma_prid is stopped Removing PID files...done I have checked /var/log/sangoma_mgd.log file. But nothing was there. Could any please tell me where I made mistake? Thanks, Mag