Dear All,
         I have installed Sangoma PRI card in machine with following steps,
                 * wget ftp://ftp.sangoma.com/linux/custom/3.5/wanpipe-3.5.8.7.tgz
                 * tar -xvfz wanpipe-3.5.8.7.tgz
                 * cd wanpipe-3.5.8.7
                 * make openzap
                 * make install
                 * make install_pri

           I have executed "wanrouter hwprobe" command it prints the following details,

           1 . AFT-A102-SH : SLOT=4 : BUS=3 : IRQ=11 : CPU=A : PORT=1 : HWEC=0 : V=36
       2 . AFT-A102-SH : SLOT=4 : BUS=3 : IRQ=11 : CPU=A : PORT=2 : HWEC=0 : V=36

        Card Cnt: A101-2=1

       Next I have executed wancfg_fs script to configure the sangoma for freeswitch.
It creates the following configuration files
                     * wanpipe1.conf
                     * wanpipe2.conf
                     * smg_prid.conf
                     * openzap.conf
                     * openzap.conf.xml
       I have attached those files.
       I have started the wanrouter and printed the wanrouter status,
              Wanrouter Status:

Device name | Protocol | Station | Status        |
wanpipe1    | AFT TE1 | N/A     | Connected     |
wanpipe2    | AFT TE1 | N/A     | Disconnected |

      Next I have started the smg_ctrl, but it failed to start. It prints the following things,
smg_ctrl start

Starting processes...
Loading SCTP...OK
Starting sangoma_prid...OK
sangoma_prid failed to start
check /var/log/sangoma_mgd.log for errors

Stopping running processes...
safe_sangoma not running...
sangoma_prid is stopped
Removing PID files...done

I have checked /var/log/sangoma_mgd.log file. But nothing was there.

Could any please tell me where I made mistake?

Thanks,
Mag