As I understand it, a new 'feature' was added over the weekend to resolve NAT. If you're firewall is not allowing ICMP then FS waits until it times out. At this time there is no option to disable it. Regards ________________________________ From: freeswitch-users-bounces@lists.freeswitch.org [mailto:freeswitch-users-bounces@lists.freeswitch.org] On Behalf Of Muhammad Shahzad Sent: 02 June 2009 11:40 To: freeswitch-users@lists.freeswitch.org Subject: [Freeswitch-users] Freeswitch taking too long to start up Hi, I have just upgraded Freeswitch from svn revision 12432 to 13544. I am using 32bit CentOS 5.3, "make current" command completes successfully without any errors but when i start freeswitch it take considerable time (roughly 90 - 120 seconds) to start up. During this time no message is display on console. Once successfully started, it works fine. However, this initial delay is really annoying. Is there anyway to reduce/remove this delay? Thank you. -- Muhammad Shahzad ----------------------------------- CISCO Rich Media Communication Specialist (CRMCS) CISCO Certified Network Associate (CCNA) Cell: +92 334 422 40 88 MSN: shari_786pk@hotmail.com Email: shaheryarkh@googlemail.com