As I understand it, a new ‘feature’ was
added over the weekend to resolve NAT. If you’re firewall is not allowing ICMP
then FS waits until it times out. At this time there is no option to disable
it.
Regards
From:
freeswitch-users-bounces@lists.freeswitch.org
[mailto:freeswitch-users-bounces@lists.freeswitch.org] On Behalf Of Muhammad Shahzad
Sent: 02 June 2009 11:40
To:
Subject: [Freeswitch-users]
Freeswitch taking too long to start up
Hi,
I have just upgraded Freeswitch from svn revision 12432 to 13544. I am using
32bit CentOS 5.3, "make current" command completes successfully
without any errors but when i start freeswitch it take considerable time
(roughly 90 - 120 seconds) to start up. During this time no message is display
on console. Once successfully started, it works fine. However, this initial
delay is really annoying. Is there anyway to reduce/remove this delay?
Thank you.
--
Muhammad Shahzad
-----------------------------------
CISCO Rich Media Communication Specialist (CRMCS)
CISCO Certified Network Associate (CCNA)
Cell: +92 334 422 40 88
MSN: shari_786pk@hotmail.com
Email: shaheryarkh@googlemail.com