Hi, This might be Sangoma config issue, so apologies in advance for posting it here if it is. I am waiting for Sangoma helpdesk to get back to me! But I have a Sangoma a101 and trying to get it working with Freeswitch. Have E1 line coming from telco and everything set up correctly (to my best efforts), however when Freeswitch starts, it says: 2009-07-30 15:17:15.446569 [ERR] mod_openzap.c:1953 Error starting OpenZAP span 1 mode: user dialect: euro error: Also I'm getting the following Sangoma alarms: ***** w1g1: E1 Alarms (Framer) ***** ALOS: OFF | LOS: ON RED: ON | AIS: OFF OOF: ON | RAI: OFF ***** w1g1: E1 Alarms (LIU) ***** Short Circuit: ON Open Circuit: OFF Loss of Signal: ON Can someone tell me where I should be focusing my attention - on the Sangoma config or the Freeswitch config? Also what state should the Sangoma alarms be in when Freeswitch is NOT running? Should they all clear? Thanks in advance, Niall. -- -- Sremium Ltd. Reg Number: 451937 Mobile: +353 (0)87 2393174 Web: www.sremium.com The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Statements and opinions expressed in this e-mail may not represent those of Sremium. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon, this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender immediately and delete the material from any computer.