Hi, I dont know whether I can post this question here or not.. But, I dont know any other place. I hope any one can help here . I recently bought the Sangoma A101 - 1 port E1/T1 card and installed on CENT OS 5.4. I am using it for E1 PRI line in INDIA. * Here is the output of "wanrouter status" command* Devices currently active: wanpipe1 Wanpipe Config: Device name | Protocol Map | Adapter | IRQ | Slot/IO | If's | CLK | Baud rate | wanpipe1 | N/A | A101/1D/A102/2D/4/4D/8| 50 | 0 | 1 | N/A | 0 | Wanrouter Status: Device name | Protocol | Station | Status | wanpipe1 | AFT TE1 | N/A | Connected | * Here is the output of "**wanpipemon -i w1g1 -c Ta" the * ***** w1g1: E1 Rx Alarms (Framer) ***** ALOS: OFF | LOS: OFF RED: OFF | AIS: OFF LOF: OFF | RAI: OFF ***** w1g1: E1 Rx Alarms (LIU) ***** Short Circuit: OFF Open Circuit: OFF Loss of Signal: OFF ***** w1g1: E1 Tx Alarms ***** AIS: OFF | YEL: OFF ***** w1g1: E1 Performance Monitoring Counters ***** Line Code Violation : 1163 Far End Block Errors : 0 CRC4 Errors : 0 FAS Errors : 3 Rx Level : > -2.5db I spoke with my telco, they checked the line and there is no issue. I don't know what to do? Pls anyone help me? Regards, Venkat.