you have 2 FXS modules. try to swap modules 0 and 1 to isolate whether the problem is in the daughter board or on the motherboard. this is far i can suggest. :-) On Mon, May 30, 2011 at 7:59 PM, Johan Helsingius <julf@julf.com> wrote:
just to make sure. did u supply power to the interface card? it requires one just like hard disk/optical drives.
I did, and nothing has changed in the hardware setup. Or not knowingly. Seems one of the modules might have blown, here is an extract from dmesg:
[ 10.131010] Module 0: Installed -- AUTO FXS/DPO [ 10.644001] Unable to do INITIAL ProSLIC powerup on module 1 [ 11.156017] Unable to do INITIAL ProSLIC powerup on module 1 [ 11.156019] Module 1: FAILED FXS (FCC) [ 11.356308] Module 2: Installed -- AUTO FXO (FCC mode) [ 11.556308] Module 3: Installed -- AUTO FXO (FCC mode)
[ 11.604259] Found a Wildcard TDM: Wildcard TDM400P REV E/F (3 modules)
So one of the 4 modules refused to power up.
Julf
_______________________________________________ FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org