[Freeswitch-users] Problems with wctdm / ftdm / TDM400P

[Nandy Dagondon]

you have 2 FXS modules. try to swap modules 0 and 1 to isolate whether the
problem is in the daughter board or on the motherboard. this is far i can
suggest. :-)


On Mon, May 30, 2011 at 7:59 PM, Johan Helsingius <julf at julf.com> wrote:

> > just to make sure. did u supply power to the interface card? it requires
> one
> > just like hard disk/optical  drives.
>
> I did, and nothing has changed in the hardware setup. Or not
> knowingly. Seems one of the modules might have blown,
> here is an extract from dmesg:
>
> [   10.131010] Module 0: Installed -- AUTO FXS/DPO
> [   10.644001] Unable to do INITIAL ProSLIC powerup on module 1
> [   11.156017] Unable to do INITIAL ProSLIC powerup on module 1
> [   11.156019] Module 1: FAILED FXS (FCC)
> [   11.356308] Module 2: Installed -- AUTO FXO (FCC mode)
> [   11.556308] Module 3: Installed -- AUTO FXO (FCC mode)
>
> [   11.604259] Found a Wildcard TDM: Wildcard TDM400P REV E/F (3 modules)
>
> So one of the 4 modules refused to power up.
>
>        Julf
>
>
> _______________________________________________
> FreeSWITCH-users mailing list
> FreeSWITCH-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20110530/800e7b05/attachment-0001.html