[Freeswitch-dev] OpenZAP/Q.931 question

[Michael Collins]

This one's probably for MikeJ...

I am testing out the PRI on OpenZAP.  My carrier doesn't support DMS100
so I'm using an Asterisk box to act as my telco.  I'm set up on Asterisk
with pri_net signaling in Zapata.conf, using the 24th channel as the D
channel.  I'm pretty sure that the D channels are communicating because
I'm getting an error on the actual data sent.

Here's what I see when I start up FS:
2007-11-02 22:39:46 [DEBUG] zap_isdn.c:223 zap_isdn_921_23() READ 13
------------------------------------------------------------------------
--------
[08 02 00 00 46 18 03 a9 83 82 79 01 80]

2007-11-02 22:39:46 [DEBUG] zap_isdn.c:227 zap_isdn_921_23() 931 parse
error [-3012] [Q931E_INVALID_CRV]

If I read my Q931 specs properly, the data being sent over in this case
is a RESTART (the 46 in 5th octet).  

Question: does the parse error indicate a setup issue or do you think
possibly that Asterisk isn't necessarily a good way to emulate a telco
PRI circuit?  On a DMS100, what would the proper RESTART string look
like coming from telco?

Thanks,
MC