[Freeswitch-dev] Freeswitch capabilities

[Anton]

Mike, Thanks for reply, Sangoma did confirmed that case. 
Will try doing that with less num. of cards!

On 23 October 2006 18:01, Michael Jerris wrote:
> If I recall, (sangoma may correct me on this) your going
> to have higher interrupts if you have more cards, you may
> be better off with quad or the new 8 port card.  That
> being said, no matter what you use on asterisk, I suspect
> 10 E1's will be too much from what I have seen. Also, I
> think that you would be much better off to use sip to
> interoperate with asterisk or other freeswitch on both
> the asterisk and freeswitch side.
>
> Mike
>
> > -----Original Message-----
> > From: Anton [mailto:anton.vazir at gmail.com]
> > Sent: Monday, October 23, 2006 12:37 AM
> > To: freeswitch-dev at lists.freeswitch.org
> > Subject: [Freeswitch-dev] Freeswitch capabilities
> >
> > Hi Men!
> >
> > Looking for an advice of using Freeswitch ove Asterisk.
> > I'm looking for a way to bridge a lot of TDM PRI calls
> > usind SANGOMA hardware, and I found that Asterisk just
> > is not so capable on high volume calls (10xE1 on
> > 5xDualPort cards) . I suppose Freeswitch should be more
> > capable of doind so. Asterisk eats full CPU on ~80
> > calls with no transcoding and no echo cancel. Is
> > Freeswitch capable to do so and if yes can it reliably
> > interoperate over IAX2 with other servers * and
> > Freeswitch?
> >
> > Would be gratefull for any advice,
> > With best regards,
> > Anton.
> >
> > _______________________________________________
> > Freeswitch-dev mailing list
> > Freeswitch-dev at lists.freeswitch.org
> > http://lists.freeswitch.org/mailman/listinfo/freeswitch
> >-dev
> > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options
> >/freeswitch-dev http://www.freeswitch.org
>
> _______________________________________________
> Freeswitch-dev mailing list
> Freeswitch-dev at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-d
>ev
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/f
>reeswitch-dev http://www.freeswitch.org