New subject: Originate fails for freetdm channel

26 Mar 2014

      I did install libsng_isdn before running bootstrap.sh;

these were my thoughts as well that I might have missed installing
libsng_isdn before running bootstrap.sh so after finding the issue, I
re-compiled libsng_isdn, ran make clean on FS and then ran bootstrap.sh
again but the check was still failing.

Also, I have installed freetdm several times and got the FS installation to
work flawlessly before but the configuration scripts are not detecting
libsng correctly this time. Any ideas?

Regards,
Kshitij Saxena

---------------------

Hi,

Did you follow the install instructions for wanrouter driver and
libsng_isdn library?  These have to be performed before the Freeswitch
bootstrap step.  Freeswitch detects installed libraries during the
./bootstrap step.
http://wiki.sangoma.com/wanpipe-freeswitch-ftdm-installation

Regards,
Robert

On Tue, Mar 25, 2014 at 11:34 PM, Kshitij Saxena <ksaxmail@gmail.com> wrote:
...
Solved this in a very hacky way - replying here in case this helps someone
(although very hacky).
open freeswitch/libs/freetdm/configure.ac
find HAVE_SNG_ISDN="no"
and change it to HAVE_SNG_ISDN="yes"
finally, build FS again
Please take care that this tells configure to build ftmod_sangoma_isdn
even if its check for the library fails!
Is there a less hacky / more straitforward way?
Regards,
Kshitij Saxena
On Tue, Mar 25, 2014 at 7:46 PM, Kshitij Saxena <ksaxmail@gmail.com>wrote:
...
ok. The problem seems to be that ftmod_sangoma_isdn hasn't been compiled.
This is strange because I had compiled both wanpipe as well as
libsng_isdn before configuring FS.
I repeated the steps again in case I had missed something - recompiled
libsng_isdn, began FS with make clean, then bootstrap, then configure and
make but ftmod_sangoma_isdn is still not being compiled!
Am I missing something? Is this a bug?
Regards,
Kshitij
On Tue, Mar 25, 2014 at 6:03 PM, Kshitij Saxena <ksaxmail@gmail.com>wrote:
...
The setup is a Sangoma A101E card being run through Wanpipe 7.0.10 on an
Ubuntu 13.10 machine.
wanrouter status shows "connected" but "originate freetdm/1/a/xxxxxxxxxx
&bridge..." fails with the following error:
[ERR] ftdm_io.c:2674 [s1c1][1:1] outgoing_call method not implemented in
this span!
Note that originate is successful with for other cahnnels (i.e.
"originate user/1001 &bridge(9198)" works for example)
Would appreciate any guidance. Thanks!
Regards,
Kshitij Saxena

Re: [Freeswitch-users] Originate fails for freetdm channel

Kshitij Saxena

Michael Jerris

tags

participants (2)