Ok it is NI2 according to Qwest, Mike Peace Network Analyst EDCO, The Document People Direct 417-447-3367 From: freeswitch-users-bounces@lists.freeswitch.org [mailto:freeswitch-users-bounces@lists.freeswitch.org] On Behalf Of Mike Peace Sent: Wednesday, August 26, 2009 8:58 AM To: freeswitch-users@lists.freeswitch.org Subject: Re: [Freeswitch-users] Moved Freeswitch to new subnet. I found and edited openzap.cong file, the openzap.conf.xml file is in the correct dir but the only example I can find is for a Euro E1 setup not a US T1. I I have turned up data T1 circuits for WAN links before but not telco stuff. The provider is Qwest, I’ll have to ask about the NI2 , DMS question. Mike From: freeswitch-users-bounces@lists.freeswitch.org [mailto:freeswitch-users-bounces@lists.freeswitch.org] On Behalf Of Michael S Collins Sent: Wednesday, August 26, 2009 3:02 AM To: freeswitch-users@lists.freeswitch.org Subject: Re: [Freeswitch-users] Moved Freeswitch to new subnet. I have looked at that but I am confused on which files need to be edited. Since I have already installed in Wanpipe mode with the Sangoma card I skipped straight to the Wanpipe section. It mentions setting the [span wanpie PRI_1] etc in the openzap.conf then further down it mentions editing the autoload_configs/openzap.conf.xml with a completely different format of config. Are these the same file? If not where does the first one mentioned reside? These are two different files. The openzap.conf file is in the freeswitch/conf directory. It is for configuring OZ to talk to the Sangoma card. The openzap.conf.xml file is for configuring the actual openzap module in FreeSWITCH. The specs you listed on the T1 you have indicate that it's a PRI. However, you need to know which protocol, like NI2 or DMS. Have you ever done a PRI turn up? Who is the carrier? -MC