I attempted to build rpm's from the included spec file using a non-root user build environment. The steps I used are as follows: 1. Check build deps @ http://wiki.freeswitch.org/wiki/Installation_Guide#RHEL.2FCentOS 2. Pulled a copy of trunk in the SOURCES directory & tar/bzip2 it as expected by the spec: svn co http://svn.freeswitch.org/svn/freeswitch/trunk freeswitch-1.0.4 tar cjf freeswitch-1.0.4.tar.bz2 freeswitch-1.0.4/ 3. Copy spec to SPECS directory: 4. Pull in Source (Source0 doesn't exist yet, I make it above): for SOURCE in $(awk '/^Source[1-9][0-9]*:/ {print $2}' freeswitch.spec); do wget -P ../../SOURCES/ $SOURCE; done 5. Check spec in svn copy for deps: yum install $(awk -v ORS=" " '/^BuildRequires:/ {print $2}' freeswitch.spec) 6.Build rpm: rpmbuild -ba freeswitch.spec After some time, near the end I see various issues like the following: making install mod_speex installing mod_speex.so quiet_libtool: install: warning: `/home/builder/rpmbuild/BUILD/freeswitch-1.0.4/libfreeswitch.la' has not been installed in `/opt/freeswitch/lib' It also seems to download everything it would normally again, then fails with several errors like the following: RPM build errors: File not found by glob: /var/tmp/freeswitch-1.0.4-1-root-builder/opt/freeswitch/mod/ozmod_wanpipe.so* Installed (but unpackaged) file(s) found: /opt/freeswitch/conf/autoload_configs/cidlookup.conf.xml /opt/freeswitch/conf/autoload_configs/nibblebill.conf.xml /opt/freeswitch/conf/autoload_configs/unimrcp.conf.xml /opt/freeswitch/conf/lang/ru/demo/demo-ivr.xml . . . After which no rpm's are built? Anyone know what tricks are still needed with the spec from svn? Thanks! jlc