I setup a FreeSWITCH pbx with a Sangoma A102D card, the latest FreeSWITCH as of yesterday, and Wanpipe 3.5.11. I have found that I cannot use both PRI ports with Sangoma's smg_prid. The first one always works great but the second one never works. I get the following error: 2010-05-05 09:42:02.573743 [CRIT] ozmod_sangoma_boost.c:257 SPAN is not online. 2010-05-05 09:42:02.573743 [ERR] switch_ivr_originate.c:2480 Cannot create outgoing channel of type [openzap] cause: [NORMAL_CIRCUIT_CONGESTION] When I start FreeSWITCH up I get this error on the console right after all the channels are activated. 2010-05-05 07:25:59.414444 [ERR] ozmod_sangoma_boost.c:1534 Error: Opening MCON Socket [-1] Address already in use The configs are below: openzap.conf [span wanpipe 1] name => 1 trunk_type =>t1 b-channel => 1:1-23 [span wanpipe 2] name => 2 trunk_type =>t1 b-channel => 2:1-23 openzap.conf.xml <configuration name="openzap.conf" description="OpenZAP Configuration"> <settings> <param name="debug" value="0"/> </settings> <boost_spans> <span id="1"> <param name="node" value="cpe"/> <param name="switch" value="ni2"/> <param name="dialplan" value="XML"/> <param name="context" value="public"/> </span> <span id="2"> <param name="node" value="cpe"/> <param name="switch" value="ni2"/> <param name="dialplan" value="XML"/> <param name="context" value="public"/> </boost_spans> <analog_spans> </analog_spans> </configuration> I'm dialing with this dial string. <action application="bridge" data="{origination_caller_id_number=${outbound_caller_id_number}}openzap/2/a/$1"/> I am certain the rest of this config works fine because the other PRI works great. I have also attempted to use FreeSWITCH without Sangoma's smg_prid by specifying a d-channel in openzap.conf. That seems to work but calls tend to drop frequently. I would rather just use Sangoma's smg_prid. I also attempted a hybrid config where FreeSWITCH worked without smg_prid on the first PRI and the second PRI was handled by smg_prid. That config worked except for the dropped calls that happen with using FreeSWITCH to manage the d-channel. My question is how can I get two PRI's working with Sangoma's smg_prid? Thank you. Bryan