Hi, I'm having problems to connect calls using a digium tdm800p card. The problem only happens with the ports that are connected to a intelbras 4100 gsm interface, ports connected to the POTS are not affected. I'll try the best I can to express the situation: 1) Cold restart the gsm interface and wait for it to boot up 2) Try to place a call using it (freetdm/<port>/<number>) 3) The call stays silent, after a while the carrier reports that a invalid number has been informed 4) At this point, all following calls always return busy. If I connect an analog phone to the gsm interface and start dialing digits, it gives a busy tone right away, before I finish dialing the number 5) Cold restart the gsm interface again 6) Try to place a call using it (freetdm/<port>/<number>) 7) The calls stays silent, but this time I type the same number again. 8) The call connects. This problem does not happen with an analog phone or with chan_dahdi (asterisk), just with freetdm. My assumption is that when freetdm opens the channel for the first time and starting sending the dtmf digits, the gsm interface is not able to read them and sits waiting, after a while it timeouts and stops working, even for further calls. Here is my freetdm.conf: [span zt dahdi_span_1] trunk_type => FXO debugdtmf => yes analog-start-type => kewl fxo-channel => 1:1-6 zt.cont: [defaults] codec_ms => 20 wink_ms => 150 flash_ms => 750 echo_cancel_level => 64 rxgain => 0.0 txgain => 0.0 dahdi/system.conf: loadzone=br defaultzone=br fxsks=1-6 echocanceller=mg2,1-6 If anybody could help me with this I would really aprecciate. Regards. -- Atenciosamente, Antônio Modesto