Perhaps an issue in packet throughput (packets-per-second) on the NIC or any virtualized driver levels? -- Craig On Sat, Jul 11, 2020 at 10:57 AM Joel Serrano <joel@textplus.com> wrote:
Have you checked the max-sessions (switch.conf.xml) and the ulimits etc (OS level)?
On Sat, Jul 11, 2020 at 03:45 Sergey Safarov <s.safarov@gmail.com> wrote:
Need looks FreeSwitch logs.
On Sat, Jul 11, 2020 at 12:53 PM David Villasmil < david.villasmil.work@gmail.com> wrote:
I get to 2000 channels fine. My question is why can’t I higher without calls failing? FS never uses more than 40% CPU and 20 gb RAM. Config is basically vanilla, I unloaded most unnecessary modules, too.
On Sat, 11 Jul 2020 at 04:59, Sergey Safarov <s.safarov@gmail.com> wrote:
Just for info. Can you try on windows?
That does not matter. On Linux, I get results with 50 calls per second, every call continues for 24 seconds, 1000 concurrent calls, and 10 000 total calls with only 3 failed calls. Tested kazoo cluster, more complex cluster then standalone freeswitch. So must work on Linux
On Sat, Jul 11, 2020 at 6:09 AM Sergey Safarov <s.safarov@gmail.com> wrote:
SIPP can record failed call ID Using this call-id you search for FreeSwitch logs. Also, you can record all network traffic using dumpcap or tcpdump utility to disk. Later you can open these pcap files using sngrep utility and check waht is wrong with failed calls.
On Sat, Jul 11, 2020 at 5:07 AM Alex Sibyakin <alex@freeswitch.com> wrote:
Hello,
What is your OS? What is your Sofia configuration?
What the vmstat -w -S M 1 10 says?
Can you try without Docker?
Regards, Alex
On Fri, 2020-07-10 at 19:53 +0100, David Villasmil wrote:
Hello all,
Let's assume i have a 28 CPU (56 cores) with 64gb RAM. I'm load-testing that box with something like this:
SIPp->--\ /----> FS1 ---->FS SIPp->--/ \----> FS2
SIPp is simply sending calls with rtp to FS. FS just forward the calls to FS1 and FS2 based on some very simple decision. FS1 and FS2 simply answer and execute echo. At ~2000 channels FS fails to reply to some SIP messages, basically calls are timing out, answer ratio goes down. BUT CPU never goes over 45% on the FS and memory is ample. I don't see packe drops on the interface. FS is running in a docker.
I'm wondering whether FS would use all of the available CPU or am I hitting some other limit somewhere.
Any insight is welcomed!
Regards,
David Villasmil email: david.villasmil.work@gmail.com phone: +34669448337
_________________________________________________________________________
-- Regards,
David Villasmil email: david.villasmil.work@gmail.com phone: +34669448337 _________________________________________________________________________