On Fri, Jun 17, 2011 at 7:08 PM, John <freeswitch@earthspike.net> wrote:
Mike, Shouldbe,
We now have CLIP on the line for sure, and I ordered COLP at the same time and am assured that that has been turned on as well, but I still cannot get outgoing CLI to work properly. Mike, you mention setting the TON to 'national'; where is that setting?
At the moment, my dialplan looks like http://pastebin.freeswitch.org/16548 with . An outgoing call gives the log 7 at http://pastebin.freeswitch.org/16549 (numbers have been changed to protect the innocent!) but the number that 01234 567890 sees on their Caller ID is not 876543 but the main number of the line (876540, say). I have tried setting the outgoing_caller_id_number to 6, 10 and 11 digits, restarting FS after each change, but with no success.
The service provider has only one clue to offer: "With regards to the configuration at the exchange, the line is set to 6 digits to switch." which makes eminent sense, and suggests that I should be presenting 6 digits. Incoming calls have a 6 digit called number and 10 digit calling number.
Thanks for the help so far. Any other ideas?
John
I don't have any experience with FS connecting over ISDN so can't help you much further on the FS configuration:-( However on the lines, I would be very tempted to see if you can borrow a BRI tester, or what I've frequently used in the past is an Eicon/Dialogic card as the test functions (under windows) are nearly as good, that might help you see if it _is_ a BT problem, or a FS configuration issue. It would need a 2k/XP machine, but something like http://cgi.ebay.co.uk/EICON-DIVA-2-01-PCI-GRAPHICS-CARD-/270761571564 is what I have used in the past. I think I might have one of the PCMCIA ones somewhere, but I'd need to test it still works I'm fairly sure that the "6 digits to switch" is what they are sending to you, not what they are expecting from you. I can't access out remaining BRI (Avaya) PBX from here, but on our PRI (again Avaya) switches, we are sending 10 digits. Cheers