Here are my instructions to install the wanpipe driver and I have not had your problem: 1) Download the following Wanpipe driver tarball wanpipe-<version>.tgz 2) Store the wanpipe-<version>.tgz file in the /opt folder. 3) tar xvfz wanpipe-<version>.tgz 4) cd wanpipe-<version> 5) make openzap 6) make install 7) make install_pri 8) wanrouter hwprobe // confirms successful wanpipe installation 9) /usr/sbin/wancfg_fs // starts wanpipe configuration utility 10) 1=NO // Change Freeswitch Configuration Directory 11) 1=T1 // Select Media Type 12) 1=YES (keep) // Configure Port 1 T1, B8ZS, ESF 13) 1=NORMAL // Select Clock 14) 1=NATIONAL // Select Switchtype 15) 1=CPE // Select Signaling Type 16) 1 // Input Group # 17) 1=YES // Enable H/W DTMF Detect 18) 1=YES // Enable FAX Detect 19) 1=YES=CONTINUE // Configuration Complete 20) 1=YES // Save Configuration 21) 1=YES // Wanrouter start on reboot 22) 1=YES // smg_ctrl start/stop on wanrouter start 23) Done. Jerry _____ From: Magesh R [mailto:magesh.freeswitch@gmail.com] Sent: Tuesday, January 12, 2010 8:21 PM To: freeswitch-users@lists.freeswitch.org Subject: [Freeswitch-users] Sangoma PRI installation for FreeSWITCH Dear All, I have installed Sangoma PRI card in machine with following steps, * wget ftp://ftp.sangoma.com/linux/custom/3.5/wanpipe-3.5.8.7.tgz * tar -xvfz wanpipe-3.5.8.7.tgz * cd wanpipe-3.5.8.7 * make openzap * make install * make install_pri I have executed "wanrouter hwprobe" command it prints the following details, 1 . AFT-A102-SH : SLOT=4 : BUS=3 : IRQ=11 : CPU=A : PORT=1 : HWEC=0 : V=36 2 . AFT-A102-SH : SLOT=4 : BUS=3 : IRQ=11 : CPU=A : PORT=2 : HWEC=0 : V=36 Card Cnt: A101-2=1 Next I have executed wancfg_fs script to configure the sangoma for freeswitch. It creates the following configuration files * wanpipe1.conf * wanpipe2.conf * smg_prid.conf * openzap.conf * openzap.conf.xml I have attached those files. I have started the wanrouter and printed the wanrouter status, Wanrouter Status: Device name | Protocol | Station | Status | wanpipe1 | AFT TE1 | N/A | Connected | wanpipe2 | AFT TE1 | N/A | Disconnected | Next I have started the smg_ctrl, but it failed to start. It prints the following things, smg_ctrl start Starting processes... Loading SCTP...OK Starting sangoma_prid...OK sangoma_prid failed to start check /var/log/sangoma_mgd.log for errors Stopping running processes... safe_sangoma not running... sangoma_prid is stopped Removing PID files...done I have checked /var/log/sangoma_mgd.log file. But nothing was there. Could any please tell me where I made mistake? Thanks, Mag