I guess it tries to listen to one of the other interfaces instead. You can force what IP to listen on, but the most obvious would maybe be to get rid of the IP's on eth0 and eth1 - since these interfaces doesn't need IP addresses anyway. /Peter ________________________________________ Från: freeswitch-users-bounces@lists.freeswitch.org [freeswitch-users-bounces@lists.freeswitch.org] för Sharad Garg [sharad@coraltele.com] Skickat: den 17 april 2012 12:22 Till: freeswitch-users@lists.freeswitch.org Ämne: [Freeswitch-users] Freeswitch and network bonding Hi All I am trying to run the Freeswitch with network bonding. My scanerio is - eth0 - 192.168.4.25 eth1 - 192.168.4.30 bond0 - 192.168.4.65 This is the virtual IP which is to access the freeswitch. The issue is when I make a call to 192.168.4.65 which is a virtual ip of Freeswitch system, this call dies not reach at Freeswitch. When I do wireshark, wireshark shows `Destination unreachable'. The same freeswitch works well if I disable the network bonding. Here I would like to mention that I have not made any kind of settings in Freeswitch to run with network bonding. Can someone help me why call is not arriving at Freeswitch when network bonding is enabled. Thanks in advance. Best Regards Sharad _________________________________________________________________________ Professional FreeSWITCH Consulting Services: consulting@freeswitch.org http://www.freeswitchsolutions.com FreeSWITCH-powered IP PBX: The CudaTel Communication Server http://www.cudatel.com Official FreeSWITCH Sites http://www.freeswitch.org http://wiki.freeswitch.org http://www.cluecon.com FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org !DSPAM:4f8d42f932761614173760!