Hi! The router is a ASUS router but it is running the tomato firmware which runs miniupnd. In the debug I see the message: 2010-10-24 08:02:59.178918 [DEBUG] sofia.c:956 nua_i_outbound: unknown event 8: 101 NAT detected This is what I see below. I hope I enabled all debug messages. I thought I saw some xml type messages earlier, but not sure how I enabled them. nta_outgoing: RTT is 67.958 ms outbound(0xb6e07c00): NAT binding changed: [210.xx.xxx.xx]:5080 != [58.xxx.xx.xx]:5080 nua(0xb6e07c00): event i_outbound 102 NAT binding changed nua: nua_application_event: entering 2010-10-24 09:05:08.849525 [DEBUG] sofia.c:956 nua_i_outbound: unknown event 8: 102 NAT binding changed On Sun, Oct 24, 2010 at 1:08 AM, Rupa Schomaker <rupa@rupa.com> wrote:
btw: what router are you using?
On Sat, Oct 23, 2010 at 9:06 AM, Rupa Schomaker <rupa@rupa.com> wrote:
In a upnp config, FS is depending on the router to notify it of the ip address change. It is possible the upnp message(s) aren't formatted as expected. If you turn on debug logging you'll get the upnp messages on the console. If you can pastebin the capture of those while dropping and restarting the dsl connection I can maybe see if there is something obvious going on. The debug should also have messages related to the processing of those upnp messages.
On Sat, Oct 23, 2010 at 7:04 AM, Mark Campbell-Smith < mcampbellsmith@gmail.com> wrote:
HI!
I know this question must have been answered 100's of times....
My adsl is a bit dodgy at the moment and tends to go up and down; which means I get assigned a new ip address from my ISP. FS is nat'd behind a upnp capable router.
The problem is that FS does not seem to be detecting the change. For both the internal and external profile, I have auto-nat setup, and I have tried stun and host settings in vars.conf. When I issue a nat_map status I see my old IP address, and if I then issue a nat_map reinit, I see the new public IP address. How can I get this to be automatic?
Also the public IP address shown in the nat_map status is not the same as shown in the sofia profile internal/external printouts. Why is this?
I'm sure this is configuration, just not sure what to change.
Thanks!
_______________________________________________ FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org
-- -Rupa
-- -Rupa
_______________________________________________ FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org