Thanks, Gavin. That would be really useful. John On 08/07/11 19:51, Gavin Henry wrote:
Hi John,
We set this up for a customer using a Sangoma card and FusionPBX not long ago. I can dig out the config next week when back in the office. It's for ISDN30e but should help.
Thanks.
On 7/7/11, John<freeswitch@earthspike.net> wrote:
Jan,
I have tried every combination of unknown, national and international with every combination of number length. I have also confirmed that by using wanpipemon to capture the D-channel messages. When I went through them with Wireshark and compared them with Q.931, everything was being set correctly by the Sangoma card/drivers. I am at the point now where I need someone who has worked with BT ISDN switches to tell me what they can accept. It seems that this is a national secret over here, or instead that they can accept almost anything and my lines have been configured to override the outgoing calling number with the base number. Either way, the only way in which I think I am now going to get a result is by booking a fault. Your helpful comment about modern switches being able to work this out also confirms that I am probably not looking at a Q.931 formatting error on my part, but on a blockage in the exchange. I don't have a problem with the called number, for example.
John
On 07/07/11 23:09, Jan Berger wrote:
I must admit I don't remember what CLIP and CLOP is -- and my Q.931 experience is getting a bit rusty...
Can you get a snoop of L3 out and in so I can see what you send and what the switch responds back?
I prefer to use Called and Calling -- The numbers contain a few bits that tell what number this is. The most common are unknown, national and international. These bits must match the actual number you send. The 10 digit number is a unknown, the 11 digit is a national. International start with 00 nn
On top of that you will face that modern switches are quite capable and able to configure whatever behaviour they want per line with regards to called/calling -- so you need to find out exactly what the switch expect on both called and caller for outgoing to behave as you want.
/Jan
On our PRI systems we are sending 10 digits (2071231234), and on the BRI system we are sending 11 digits (02071231234).