Hi, First of all - are you running latest GIT HEAD? If you're not, please upgrade first. If you are, please file a Jira with debug information attached to it, so we can find the cause for this. /Peter ________________________________________ Från: freeswitch-users-bounces@lists.freeswitch.org [freeswitch-users-bounces@lists.freeswitch.org] för Simon Leck [simon0922@gmail.com] Skickat: den 3 maj 2011 08:01 Till: freeswitch-users@lists.freeswitch.org Ämne: [Freeswitch-users] FreeSWITCH calls unable to be released issue Dear All, Re: FreeSWITCH calls unable to be released issue: At this moment we are facing some major issue in Freeswitch hope somebody out there can give us some kind advice on how to rectify the issue mentioned below. The major problem we are facing at this stage is “Channels or Calls unable to be released”, and we are sure the response of command we used“show calls” and “show channels” are correct and reliable. We found this situation, after we pass through massive traffic to FreeSWITCH, and then, get into the fs_cli, and exec “status”, “show channels” and “show calls”, we will have different numbers for each response, even when we turn off the source traffic, the “status” response 0 sessions, and type “show calls” we will still see 5, 10 or more calls on it, and when we type “show channels” it would show 6,15 or more channels; we did try to modify mod_command to retrieve the status from core.db, and the results are still the same, the source data from core.db do not matched, some calls / channels still could not be released. We had studied the wiki to find solutions, put core.db to tmpfs, setting higher memory… etc, but all still could not worked, till now we are still plague by these problems, We then more a step further by trying to figure out how to put core.db into mysql or some database via doing research on the internet, but we have no luck as there are no further information about how to put core.db into mysql. Please somebody out there if you know how to do this kindly give us a guidance or point us to somebody who could advise us on how to rectify this issue. Yet another issue we have on hand is Freeswitch could not stop fluently when there are calls has not been fully released and this cause our status Monitoring system to fail and could not restart Freeswitch. Looking forward to getting some prompt reply soonest. Thanks again Everybody. Simon Leck IM: simonleck@worldteltech.com<mailto:simonleck@worldteltech.com> Cell: +886918981838 !DSPAM:4dbf9acc32761034989110!