John, Just curious - why are you using zaptel at all? Does it provide something for you that the wanpipe drivers do not? I use Sangoma only with Sangoma cards and I have a lot of success. -MC On Wed, Apr 8, 2009 at 3:19 PM, John Wehle <john@feith.com> wrote:
Okay, a few things. First off, the wanpipe2.conf file has a booboo.
Don't think so.
This line is WRONG: TDMV_DCHAN = 0
Not exactly. My understanding is you can use either:
wanpipeX.conf: TDMV_DCHAN = 0 zaptel.conf: dchan = 24 (or in our case 48 since it's the second span)
which means use zaptel to handle the d-channel hdlc or
wanpipeX.conf: TDMV_DCHAN = 24 zaptel.conf: hardhdlc = 24 (or in our case 48 since it's the second span)
which means use wanpipe to handle the d-channel hdlc assuming the wanpipe driver has the necessary support (wanpipe on my platform doesn't).
Also, I recommend changing this line: wbg1 = wanpipe2, , TDM_VOICE, Comment
To this: wbg1 = wanpipe2, , TDM_VOICE_API, Comment
The sangoma voice API interface isn't available on my platform and shouldn't be necessary when using zaptel.
assuming that this is what you want then you will need to use ozmod_libpri because the default OpenZAP PRI stack does not currently support being the network side.
Are you sure? Openzap appears to contain implementations for both NT and TE. The configuration file supports specifying either user or network for the mode. Is the NT support currently nonfunctional?
I had tried configuring the Cisco as the NT with similar results.
I don't see where timing is specified
It's the same T1 which was being used for RBS between FreeSWITCH and the Cisco so that timing (etc) should be okay. No errors are showing up at the physical level and the Cisco reports Layer 1 as active.
The trace on the Cisco seems to show Layer 2 coming up (timestamps 22:53:44.264 through 22:54:21.760), then there's a long pause during which no Receive Ready frames are received from FreeSWITCH. At this point the Cisco gets unhappy and marks Layer 2 as down.
If nothing obvious comes to anyone's mind, then I'll simply need to trace through the FreeSWITCH ISDN code and see what's going on.
-- John ------------------------------------------------------------------------- | Feith Systems | Voice: 1-215-646-8000 | Email: john@feith.com | | John Wehle | Fax: 1-215-540-5495 | | -------------------------------------------------------------------------
_______________________________________________ Freeswitch-users mailing list Freeswitch-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org