Alex, The stock OpenZAP PRI handler doesn't do net, it only does terminal. You'll need to use the ozmod_libpri method if you want to have FS be a PRI/Net: http://wiki.freeswitch.org/wiki/OpenZAP#Adding_libpri_Support -MC On Fri, Jun 26, 2009 at 12:02 AM, Alex Green <alexg@etherstack.com> wrote:
Summary: After having a play with analogue openzap, I have moved to a TE210p and am having some trouble getting a test PRI to PRI call working.
For the analogue card I had written an app where you give it a number via the command line, it will calls you and by pressing digits you can either record or playback PCM. Using openzap was fairly straight forward if you knew what you are doing (first time was tedious trying to figure out the calls, values and state transitions). But it works fine.
For the two span PRI card I am having a bit less luck. I have the RX connected to the TX for both spans. I have the config set up correctly (according to ztscan and openzap load messages). This is how I start the PRI call. I do this for both spans with error checking and for zap_configure_span() I use "net" instead of "te" on the second span.
=========================================== // Configure the span: zap_configure_span("isdn", span_PRI_1, on_signal, "mode", "te", "dialect", "q931", TAG_END) // Start the span: zap_span_start(span_PRI_1)
// Make an outgoing call zap_channel_outgoing_call(span_PRI_1->channels[1]); <===========================================
This gives me the following output:
=========================================== [DEBUG] src/ozmod/ozmod_isdn/ozmod_isdn.c:1029 state_advance() 5:1 STATE [DIALING] [DEBUG] src/ozmod/ozmod_isdn/ozmod_isdn.c:1757 q931_rx_32() WRITE 32
-------------------------------------------------------------------------------- [08 02 00 02 05 04 03 80 90 a3 18 03 a1 83 81 1e 02 80 83 28 00 6c 02 01 80 70 01 81 7d 02 91 81]
[DEBUG] src/ozmod/ozmod_isdn/ozmod_isdn.c:993 zap_isdn_921_23() READ 32
-------------------------------------------------------------------------------- [08 02 00 02 05 04 03 80 90 a3 18 03 a1 83 81 1e 02 80 83 28 00 6c 02 01 80 70 01 81 7d 02 91 81]
[DEBUG] src/ozmod/ozmod_isdn/ozmod_isdn.c:997 zap_isdn_921_23() 931 parse error [-3002] [Q931E_ILLEGAL_IE] <===========================================
The second channel is reading the data that is being written, which I guess is a good start. But, how do I go from here to actual calls?
I am sure it is something simple that I am overlooking. Any help is really appreciated. Thanks,
Dr Alex Green.
_______________________________________________ Freeswitch-dev mailing list Freeswitch-dev@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-dev http://www.freeswitch.org