If I recall, (sangoma may correct me on this) your going to have higher interrupts if you have more cards, you may be better off with quad or the new 8 port card. That being said, no matter what you use on asterisk, I suspect 10 E1's will be too much from what I have seen. Also, I think that you would be much better off to use sip to interoperate with asterisk or other freeswitch on both the asterisk and freeswitch side. Mike
-----Original Message----- From: Anton [mailto:anton.vazir@gmail.com] Sent: Monday, October 23, 2006 12:37 AM To: freeswitch-dev@lists.freeswitch.org Subject: [Freeswitch-dev] Freeswitch capabilities
Hi Men!
Looking for an advice of using Freeswitch ove Asterisk. I'm looking for a way to bridge a lot of TDM PRI calls usind SANGOMA hardware, and I found that Asterisk just is not so capable on high volume calls (10xE1 on 5xDualPort cards) . I suppose Freeswitch should be more capable of doind so. Asterisk eats full CPU on ~80 calls with no transcoding and no echo cancel. Is Freeswitch capable to do so and if yes can it reliably interoperate over IAX2 with other servers * and Freeswitch?
Would be gratefull for any advice, With best regards, Anton.
_______________________________________________ Freeswitch-dev mailing list Freeswitch-dev@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-dev http://www.freeswitch.org