[Freeswitch-users] FS behind an IPCOP firewall

[Michael Collins]

What do you see on the FS console? Make sure you are in debug loglevel.
Also, you may want to turn on SIP trace as well so that you can observe the
actual SIP messages being sent and received.

-MC

On Tue, Aug 30, 2011 at 7:11 AM, Praveen Ray <pray at theprossergroup.com>wrote:

> Hi
> Here's is my setup. It's not that complicated.
>
>             172.168.128.0/24 subnet
> FS <-------------------------------------------> IPCOP Firewall
>                                                                    |
> |                 10.10.0.0/24 subnet
> Extension 1000 <--------------------------------->|
> |<-------------------------------------------- Extension 1001
> (172.168.128.188)
> (10.10.0.170)
>
> Firewall is set to allow all UDP traffic in the port rane 1024-65000
> between these two subnets.
>
> Both 1000 and 1001 register successfully with FS. I can make outgoing calls
> (using vitelity) using both. I can call 1000 from 1001 ok. However,
> calling 1001 from 1000 doesn't work. It goes right to 1001's VM. It's as if
> FS doesn't know 1001 is registered. My config is almost same as what
> comes with vanilla FS install (except I defined outgoing vitelity and
> 1000.xml and 1001.xml extensions).
>
> Any obvious config I'm missing? Thanks in advance.
>
>
>
> FreeSWITCH-users mailing list
> FreeSWITCH-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20110831/ea8667cb/attachment.html