[Freeswitch-users] Accessing wanpipe from openVZ container

[Brian West]

Its basically the same thing.. let the VE have access to the hardware.

/b

On Oct 4, 2010, at 7:18 AM, Russell Mosemann wrote:

> We are using openVZ with FreeSWITCH running in a container. In another situation, I successfully installed DAHDI in the host node, exported the devices to the container and installed libpri in the container. FS could access the card without any problems.
> 
> We are moving to a Sangoma A101D and an A200. I have installed the wanpipe drivers in the host node (make freetdm and make install), exported the devices to the container and installed the signaling in the container (make install_pri). However, that is not quite enough for the container, because mod_freetdm looks for libsangoma, which is in the host node. wancfg_fs does too much, because it attempts to configure wanrouter and FS at the same time.
> 
> I've looked through the FS wiki and the FS section of the Sangoma wiki, but all of the directions are for a combined installation. Is there a set of steps to install the wanpipe drivers separately from the signaling and do the individual configuration for each? Thanks.
> 
> Russell