[Freeswitch-users] Settings for maximum performance

[Max Clark]

>  If they're relatively new they should be ok but check
> /proc/interrupts to make sure (look for MSI/MSI-X/APIC next to eth0,
> eth1, etc).

You said earlier to make sure that MSI was working properly - how do I
confirm this? Or is this something I should disable? What is best for
FreeSWITCH?

Thanks,
Max

[mclark at fs-sbc02 ~]$ cat /proc/interrupts
           CPU0       CPU1       CPU2       CPU3
  0: 3969295082          0          0          0    IO-APIC-edge  timer
  1:          3          0          0          0    IO-APIC-edge  i8042
  8:          1          0          0          0    IO-APIC-edge  rtc
  9:          0          0          0          0   IO-APIC-level  acpi
 12:          4          0          0          0    IO-APIC-edge  i8042
 14:         25          0          0          0    IO-APIC-edge  ide0
 66:         57          0          0          0   IO-APIC-level
ehci_hcd:usb1, uhci_hcd:usb2, uhci_hcd:usb4
 74:          0          0          0          0   IO-APIC-level  uhci_hcd:usb3
 82:   11263182    4932428      71397      54669   IO-APIC-level  megasas
 98: 1738518148          0          0          0         PCI-MSI  eth0
NMI:      91918      46871      42712      41086
LOC: 3969292329 3969292268 3969292197 3969292121
ERR:          0
MIS:          0