[Freeswitch-users] Freeswitch taking too long to start up

[dujinfang]

Actually Brain mentioned that you can comment out switch_nat_init();  
in switch_core.c

On Jun 2, 2009, at 7:08 PM, Nik Middleton wrote:

> As I understand it, a new ‘feature’ was added over the weekend to  
> resolve NAT.  If you’re firewall is not allowing ICMP then FS waits  
> until it times out.  At this time there is no option to disable it.
>
> Regards
>
>
> From: freeswitch-users-bounces at lists.freeswitch.org [mailto:freeswitch-users-bounces at lists.freeswitch.org 
> ] On Behalf Of Muhammad Shahzad
> Sent: 02 June 2009 11:40
> To: freeswitch-users at lists.freeswitch.org
> Subject: [Freeswitch-users] Freeswitch taking too long to start up
>
> Hi,
>
> I have just upgraded Freeswitch from svn revision 12432 to 13544. I  
> am using 32bit CentOS 5.3, "make current" command completes  
> successfully without any errors but when i start freeswitch it take  
> considerable time (roughly 90 - 120 seconds) to start up. During  
> this time no message is display on console. Once successfully  
> started, it works fine. However, this initial delay is really  
> annoying. Is there anyway to reduce/remove this delay?
>
> Thank you.
>
>
> -- 
> Muhammad Shahzad
> -----------------------------------
> CISCO Rich Media Communication Specialist (CRMCS)
> CISCO Certified Network Associate (CCNA)
> Cell: +92 334 422 40 88
> MSN: shari_786pk at hotmail.com
> Email: shaheryarkh at googlemail.com
> _______________________________________________
> Freeswitch-users mailing list
> Freeswitch-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20090602/468e97b7/attachment-0002.html