[Freeswitch-users] Freeswitch taking too long to start up

[Nik Middleton]

As I understand it, a new 'feature' was added over the weekend to
resolve NAT.  If you're firewall is not allowing ICMP then FS waits
until it times out.  At this time there is no option to disable it.

 

Regards

 

 

________________________________

From: freeswitch-users-bounces at lists.freeswitch.org
[mailto:freeswitch-users-bounces at lists.freeswitch.org] On Behalf Of
Muhammad Shahzad
Sent: 02 June 2009 11:40
To: freeswitch-users at lists.freeswitch.org
Subject: [Freeswitch-users] Freeswitch taking too long to start up

 

Hi,

I have just upgraded Freeswitch from svn revision 12432 to 13544. I am
using 32bit CentOS 5.3, "make current" command completes successfully
without any errors but when i start freeswitch it take considerable time
(roughly 90 - 120 seconds) to start up. During this time no message is
display on console. Once successfully started, it works fine. However,
this initial delay is really annoying. Is there anyway to reduce/remove
this delay?

Thank you.


-- 
Muhammad Shahzad
-----------------------------------
CISCO Rich Media Communication Specialist (CRMCS)
CISCO Certified Network Associate (CCNA)
Cell: +92 334 422 40 88
MSN: shari_786pk at hotmail.com
Email: shaheryarkh at googlemail.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20090602/932019d8/attachment-0002.html