[Freeswitch-users] Openzap doesn't work

[Peter P GMX]

I had the same problem a while ago with German PRI lines (S2M).

Do you have
 <param name="dialect" value="q931"/>
in your
openzap.conf.xml?

In older Versions of openzap I used euro, in newer releases this didn't
work any more, so I used q931.

If this is not successfull,

can you post your openzap.conf.xml and openzap.xml
and the output of cat /proc/zaptel/*

Best regards
Peter

curly2009 at gmx.de schrieb:
> Hello,
>
> I'm a newbie in FS.
>
> I installed and configure Openzap and Zaptel. I have a PRI Digium Wildcard TE110P.
>
> When I call a number then I get an Error!
>
> 2009-01-12 10:20:01 [CRIT] zap_io.c:804 zap_channel_open_any() All circuits are busy.
> 2009-01-12 10:20:01 [ERR] mod_openzap.c:910 channel_outgoing_channel() No channels available
> 2009-01-12 10:20:01 [ERR] switch_ivr_originate.c:926 switch_ivr_originate() Cannot create outgoing channel of type [openzap] cause: [DESTINATION_OUT_OF_ORDER]
>
> What's wrong? Do you need any configurations?
>
> Thanks!
> Best Regards, Curly 
>
>
>