[Freeswitch-users] Freeswitch & DAHDI Kernel drivers / Hardware questions

[Raimund Sacherer]

Hello,

i was reading through the openzap wiki page and searched the wiki, the  
only thing I found about dahdi is a note from January that freeswitch  
does not work with dahdi right now.

Is this current information? Can't I use dahdi kernel drivers for  
freeswitch? As the last update to the zaptel drivers is now nearly a  
year old (1.4.12) and development has, AFAIK, ceased and new stuff  
only gehts to dahdi, correct me please if I am wrong.

Second question,

is it possible to use this hardware:

00:0d.0 Network controller: Cologne Chip Designs GmbH ISDN network  
controller [HFC-PCI] (rev 02)
	Subsystem: Cologne Chip Designs GmbH ISDN Board
	Flags: bus master, medium devsel, latency 16, IRQ 10
	I/O ports at e000 [disabled] [size=8]
	Memory at ee001000 (32-bit, non-prefetchable) [size=256]
	Capabilities: [40] Power Management version 1
	Kernel modules: hisax

with openZap? I read in the wiki (openZap.conf_Examples) something  
about HFC 4 BRI, but i do not know if this is the same as the above  
mentioned card.


I have access to some pcmcia fxo, and pcmcia isdn cards, could they be  
used? I have as well an soekris board with two pcmcia slots, could i  
use this with an fxo pcmcia card to actually drive a small home - pbx  
with freeswitch?

I did not find answers for this questions in the wiki :-)

best regards


-- 
Raimund Sacherer
-
RunSolutions
     Open Source It Consulting
-
Email: rs at runsolutions.com
tel: 625 40 32 08

Parc Bit - Centro Empresarial Son Espanyol
Edificio Estel - Local 3D
07121 -  Palma de Mallorca
Baleares

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20090825/4d47f748/attachment-0002.html