[Freeswitch-users] Reg. Freeswitch Performace on Freescale Board

[Varghese]

Hi all,
We are facing following observations/issues with freeswitch on freescale 
processor boards.
We ported freeswitch with freescale provided tool chain.
_*Freeswitch Configuration: version 1.2.6 (git version)*_
1. Only enabled mod_sofia, mod_dialplan, mod_command,mod_dptool and 
mod_console.
2. set the ulimit options and followed the steps in the following link
http://wiki.freeswitch.org/wiki/Performance_testing_and_configurations
3. SIP test tool run the load test for 500 users  in freeswitch and 
configured the dial plan to just bridge the channels
4. Freeswitch media processing is in default mode: i.e media will go 
through freeswitch
_*Freescale Board Configuration:*_
CPU : 1GHZ  PowerQUICC III, 32 bit
RAM: 1 GB
Linux- 2.6.32
Load test is conducted for SIP to SIP calls with RTP.
_*Observations:*_
Linux TOP command shows increasing CPU usage per call and increases to 
100% with only 90 calls. After that system response is very slow
We could also found delay in media.

_Surprisingly, with Asterisk 1.8 the same system configuration works 250 
calls without any problems. 
_
_*Questions:
*_1. Any one ported Freeswitch on Freescale or any embedded processors? 
Any performance figures or references will be appreciated
2. How many simultaneous calls can be possible with 1GHz PowerQUICC III 
processor ?
3. Any more settings are required in freeswitch or linux for scalability?

Thanks And Regards

Varghese Paul