[Freeswitch-users] Cisco IOS gateway: command to send connected line name

[Metik]

Yehavi,

There are a few variations of transmitting this information... If you 
have already enabled a supplemental isdn service profile, try adding the 
following to the PRI you are using:

(config-if)#isdn outgoing ie facility
(config-if)#iisdn outgoing ie extended-facility 
(config-if)#isdn outgoing display-ie
(config-if)#isdn outgoing ie caller-number
(config-if)#isdn outgoing ie called-number

-metik

Yehavi Bourvine wrote:
> Hello,
>  
>   We have a Cisco running IOS 12.4T used as our SIP-PRI gateway. On 
> the PRI there is a Nortel with Q.Sig. After a lot of configuration 
> trials I've managed to set it to send back the connected name over the 
> SIP (i.e. when a call goes from SIP to PRI, the PRI sends back the 
> connected name and then the Cisco adds it as a Remote-Party-ID). 
> However, I did not save it and a power outage cleared this config. In 
> my age I don't remember what I've done...
>  
> Anyone knows the correct config?
>  
>                            Thanks! __Yehavi:
> ------------------------------------------------------------------------
>
> _______________________________________________
> FreeSWITCH-users mailing list
> FreeSWITCH-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
>