Hi Steve, Have upgraded to the latest 1.2 stable and the problem is the same, also tried head and have the same issue. Any suggestions or shall I raise it as a bug? Regards Chris From: freeswitch-users-bounces@lists.freeswitch.org [mailto:freeswitch-users-bounces@lists.freeswitch.org] On Behalf Of Steven Ayre Sent: 19 June 2013 16:24 To: FreeSWITCH Users Help Subject: Re: [Freeswitch-users] ptime transcoding does not pass rfc2833 Your version is ancient... test whether you see the same on 1.2.10 / git v1.2.stable HEAD / git master HEAD. -Steve On 19 June 2013 15:14, Chris Martineau <chris@ghosttelecom.com<mailto:chris@ghosttelecom.com>> wrote: Hi, Does anyone know if this is a bug or a setting? If I use an incoming call ptime of say 40 on gsm to save client bandwidth and output to a carrier at 20 the rtp is transcoded to the smaller ptime fine but any rfc2833 dtmf signalling is not passed through. I have tried the pass_rfc2833 setting both on and off but it has no effect. I have done some web searches but can find nothing refering to this issue. Any help you could offer would be greatly appreciated. FreeSWITCH version: 1.0.head (git-58c3c3a 2011-11-22 18-22-57 -0600) Regards Chris _________________________________________________________________________ Professional FreeSWITCH Consulting Services: consulting@freeswitch.org<mailto:consulting@freeswitch.org> http://www.freeswitchsolutions.com FreeSWITCH-powered IP PBX: The CudaTel Communication Server http://www.cudatel.com Official FreeSWITCH Sites http://www.freeswitch.org http://wiki.freeswitch.org http://www.cluecon.com FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org<mailto:FreeSWITCH-users@lists.freeswitch.org> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org