I had a Digium TDM400P which I used successfully in another box running SwitchVox. I put it in my FreeSWITCH box. I haven't started installing the zaptel software because 'lspci' does not list the Digium card. Should it? I don't want to install the software if the board's dead. If it is dead, should I try to get it repaired or perhaps buy a Patton M-ATA? I have a Viking E-40 Entry Phone which I would like to use with FreeSWITCH. The Viking along with the Digium board did work on the SwitchVox. Thanks, Lars
I haven't started installing the zaptel software because 'lspci' does not list the Digium card. Should it? I don't want to install the software if the board's dead.
It sure does: # lspci |grep Digium 04:00.0 Ethernet controller: Digium, Inc. TDM400P (rev 11)
If it is dead, should I try to get it repaired or perhaps buy a Patton M-ATA? I have a Viking E-40 Entry Phone which I would like to use with FreeSWITCH.
That card works _perfect_ in Asterisk obviously but I have yet to make it work as well in FS.
The Viking along with the Digium board did work on the SwitchVox.
Move the position of the board amongst your available peripheral slots, there are some known compat issues, check Digiums KB. jlc
participants (2)
-
Joseph L. Casale
-
Lars Zeb