I have a setup where a session border controller is distributing calls across multiple FS servers. Calls come from device —> SBC —> one of the FS servers, where they are challenged, and subsequently established. The problem I have is that in some cases (when I determine a device already has an active call on a different FS server) I respond to the INVITE with a redirect request so that the SBC will redirect the INVITE to the server with the already-active call for that device. The problem is that before the redirect is sent by FS #1 it first sends a 407 Proxy Authorization - that goes back to the device which responds with the appropriate credentials. My FS app then sends a 302 back to the intermediary SBC, which generates a new INVITE to FS #2. That INVITE contains the same Proxy-Authorization header that was used to authenticate on FS #1, but FS #2 rejects it thusly: 2015-08-25 11:02:43.059928 [DEBUG] sofia_reg.c:1335 Send challenge for [5125265790@10.124.48.104] 2015-08-25 11:02:43.059928 [WARNING] sofia_reg.c:1339 SIP auth challenge (INVITE) on sofia profile 'device' for [5125265790@10.124.48.104] from ip 10.124.48.171 The second 407 goes back to the phone — this time from FS #2 — and the phone gives up at this point, and the call dies. I actually wanted to bypass authentication on FS #2 entirely, so I redirected the call to a different profile (one used only for these special purpose redirections), and in that profile I set auth-calls=“false” and 'apply-inbound-acl’ to include the address of the SBC. It seems, though, that by virtue of the Proxy-Authorization header being included, FS #2 is still trying to authenticate. And then authentication fails, I believe because the nonce is designed to be a one-time thing (I see the sip_authentication.last_nc column in the table of nonces seems designed to declare the nonce stale if used more than once). This seems a relatively common use case (redirection via an intermediary SBC or proxy) so I figured there must be a solution here somewhere? Thanks in advance for any and all advice. (Note: I am using an older version of FS: FreeSWITCH Version 1.0.head (git-4192195 2011-08-16 19-39-06 -0400) Dave