Hi Guys, I don't think this is currently supported but... Can I force (and keep) an FXO (FreeTDM/DAHDI) port off-hook from the dialplan or from a script? Right now when the CO sends a CPC (disconnect supervision) signal the receiving FXO port automatically goes on-hook. I'd like to be able to "busy" a line (take it off-hook and keep it off-hook) so that calls will roll-over to other lines in my CO hunt group. If not supported, could this be implemented in a relatively sane amount of time by a non-Freeswitch expert programmer? Or would this require major re-architecting? Any and all pointers appreciated. Cheers, -Slim -- Jeroen C. "Slim" van Gelderen
On Mon, Nov 1, 2010 at 3:06 AM, Jeroen C. van Gelderen <slim@thegreek.com> wrote:
Hi Guys,
I don't think this is currently supported but...
Can I force (and keep) an FXO (FreeTDM/DAHDI) port off-hook from the dialplan or from a script?
Right now when the CO sends a CPC (disconnect supervision) signal the receiving FXO port automatically goes on-hook.
I'd like to be able to "busy" a line (take it off-hook and keep it off-hook) so that calls will roll-over to other lines in my CO hunt group.
If not supported, could this be implemented in a relatively sane amount of time by a non-Freeswitch expert programmer? Or would this require major re-architecting?
Any and all pointers appreciated.
You can set the line off-hook pretty easily just adding a function or application that executes: ftdm_channel_command(chan, FTDM_CHANNEL_COMMAND_OFFHOOK, NULL); Moises Silva Senior Software Engineer Sangoma Technologies Inc. | 100 Renfrew Drive, Suite 100, Markham ON L3R 9R6 Canada t. 1 905 474 1990 x128 | e. moy@sangoma.com
participants (2)
-
Jeroen C. van Gelderen
-
Moises Silva