Can someone please help me with this. I am having the following issue. In my setup I have three phones connected to freeswitch. phn1: x2908 phn2: x2995 phn3: x2996, x2995 phn2 and phn3 are configured with X2995 as a shared line with barge enabled. In my test I place a call from phn1(x2908) to phn2(x2995) and phn3(x2995). Next I pick up the call on phn3. Next I barge into the call from phn2. At this point phn1, phn2 and phn3 are all on the call. Next I press "End Call" on phn3. Phone3 was the phone I picked the initial call on and phn2 was the phone that barged in. After pressing "End Call" on phn3, the call completely disappeared on phn3. Phone1 and phn2 were still on the call. After pressing "End Call" on phn3 I should have still seen the call appearance on phn3. But in my case phn3 showed that x2995 was not in use at all. I also did a SIP trace on this and all I see from phn3 is a BYE to the freeswitch server. Following are the registration settings set on the phone that I am using. reg.1.server.1.address="192.168.126.33" reg.1.server.1.register="1" reg.1.address="2995" reg.1.label="2995" reg.1.type="shared" reg.1.auth.userId="2995" reg.1.bargeInEnabled="1" reg.1.callsPerLineKey="4" reg.1.lineKeys="1" reg.1.outboundProxy.address="192.168.126.33" reg.1.outboundProxy.port="5060" Thanks.-