I've finally figured it out. I have to use sangoma_prid and (ozmod_sangoma_boost) <boost_spans> configuration in openzap.conf.xml. Now we have problems with sangoma_prid version (I assume), because Freeswitch logs following messages: [CRIT] sangoma_boost_client.c:356 Invalid Boost Version 100 Expecting 101 [CRIT] sangoma_boost_client.c:370 Critical Error: PQ Invalid Event lenght from boost rxlen=23 evsz=1031 Our versions: sangoma_prid: = Sangoma PRI Protocol Stack Daemon = virtual sangoma_prid: = Version: 1.25 = virtual sangoma_prid: = Date: Dec 22 2009 = virtual sangoma_prid: = Wanpipe Release: wanpipe-3.5.8.11 = FreeSwitch from SVN trunk (r16509) I assume, we have to wait for new drivers from Sangoma according to post <mike@jerris.com> Re: [Freeswitch-users] Need Help to setup freeswitch with sangoma card [Sun, 24 Jan 2010 05:13:32 -0500] Mighq Brian West napsal(a):

If you are using PRID you do not configure D channels at all. Sangoma PRID will use those already.

/b

On Jan 25, 2010, at 6:26 AM, Michal Zubáč wrote:

...

Hi.

I'm just curious. Is sangoma_prid neccessary for Freeswitch to work with E1 (PRI) line? (wanpipe & openzap mode) I stopped sangoma_prid because, when I try to start Freeswitch, openzap yells that it cannot open D-channel (/dev/wanpipe1_if16). It is already used by sangoma_prid.

But PRI calls are behaving strangely for me. Maybe this is the cause. How can I resolve this conflict?

Thanks for advice. It's possible, that I am doing some newbie mistake.

Michal Zubac

_______________________________________________ FreeSWITCH-users mailing list FreeSWITCH-users@lists.freeswitch.org http://lists.freeswitch.org/mailman/listinfo/freeswitch-users UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users http://www.freeswitch.org