Hello all,I have a project coming up that will require me to interface Freeswitch to some rather arcane legacy T1 protocols. Specifically digital loop start, and station-side digital loop start. I'm concerned that the userland support for these may be incomplete or even non-existent in FreeTDM.I've successfully used FreeTDM to connect to PRI, but when I look for span configuration options for CAS T1, the only things that I see that may be applicable are described as "analog" options, and that doesn't sound quite right for loop start on T1 channels (but I could be wrong about that). If I were to use Asterisk for this, I would configure chan_dahdi.conf for "signalling=fxs_ls" and/or "signalling=fxo_ls".Should I pursue using FreeTDM for this, or would I be smarter to incorporate a simple Asterisk gateway to handle this legacy CAS T1 signaling?Thanks,Bob
_________________________________________________________________________
Professional FreeSWITCH Consulting Services:
consulting@freeswitch.org
http://www.freeswitchsolutions.com
FreeSWITCH-powered IP PBX: The CudaTel Communication Server
http://www.cudatel.com
Official FreeSWITCH Sites
http://www.freeswitch.org
http://wiki.freeswitch.org
http://www.cluecon.com
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org