First try dialing a server side number (like the tetris sound or similar) or making an outbound call. You will want to connect fs_cli to the server and optionally the client (for FSClient it runs on port 8022 so fs_cli -P 8022) and set the mode to debug for the console (F8 I believe). Then try to make a call and see what happens. If you can't figure out the issue from the console log output use fs_logger.pl (search the wiki) i works just like fs_cli but pastes the results on the pastebin and give you a link you can reply back with so we can see the console output.
~Mitch
I am a beginner in freeswitch. I installed an image from 2600hz.com that included CentOS, freeswitch and bluebox.
I installed FSClient on 2 clients
I connect to freeswitch by using bluebox (ServerIp/bluebox) and set to device in it and assign numbers to them.
After adding account in FSClient, when I dial the number of other client in fsclient, It does not work. I also active the SIP protocol in CentOS firewall
What should I do?
Regards,
Farzaneh
_________________________________________________________________________
Professional FreeSWITCH Consulting Services:
consulting@freeswitch.org
http://www.freeswitchsolutions.com
FreeSWITCH-powered IP PBX: The CudaTel Communication Server
http://www.cudatel.com
Official FreeSWITCH Sites
http://www.freeswitch.org
http://wiki.freeswitch.org
http://www.cluecon.com
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org